Evolabel FlexWipe Pallet Labeling System

Instead of being dangerous, hard to use, large, slow and expensive, the Evolabel FlexWipe system is totally safe, user friendly, compact, fast and cost effective.

 

Enhancing safety - The unique Tactile arm eliminates any risk of crushing between the moving applicator arm and the printer or the pallet. If you put your hand in the way, the stepper motor driven arm stops and the system gives an alarm. The Tactile arm together with the Pivotable machine mount, negates the need of expensive guarding. This does not only reduce cost and release floor space, it also gives direct and quick access to the system for the operator. The label roll is replaced within 20 seconds and it takes only a minute to replace the print head or print roller when needed.

Front, Side and Rear pallet labeling

The free motion apply (patent pending) allows the same configuration to apply either of the two adjacent sides (side+front or side+back) within 12 seconds. This includes validation of all barcodes on the GS1 SSCC label. The FlexWipe system can label all three sides without having the pallet to stop if check scanning is not required.

Hygiene and Health Company

This hygiene and health company uses the Evolabel FlexWipe system for printing and applying 5 pallets per minute, on two sides including verification of all barcodes. More important still, is the fact that the system is totally safe. Both the risk of pinching between the applicator arm and the printer and the risk of getting stuck between the pallet and the whole system are eliminated with intelligent solutions.

Technical Specifications

Evolabel FlexWipe pallet applicator is a safe, compact, fast and easy to use solution for tough industrial environments. The FlexWipe is releasing flexibility due to both the compact nature of the unit and the same applicator can label all three sides towards the system.

It is built upon two servo controlled rotating movements. The inner monocoque arm can rotate 360º and the labels can leave the printer in two directions (patent pending). The outer arm holding the applicator pad can rotate 200º.

A camera based scanner is located behind the applicator pad. When a validation check scan is required the arms move and turn 180º to an optimal reading position, where all printed barcodes are checked.

Suitable printer models:	T63 G2
Minimum label size (WxL):	80x80 mm
Maximum label size (WxL):	178x240 mm
Label height position (top of label):	Standard 770 +/- 400 mm (Optional 1270 +/- 400 mm)
Label position (symmetric) at min distance (50 mm) between applicator and pallet :	237 mm from pallet corner to near edge of A5 label
Minimum separation between pallets:	750 mm
Label position (asymmetric) at smallest possible separation between pallets (450 mm):	Front/Back label: 50 mm from pallet corner to near edge of A5 label Side label: 343 mm from pallet corner to near edge of A5 label
Distance between applicator and pallet:	215 mm
Air supply:	6 bar, clean and dry
Surrounding temperature (operation):	+5°C to +40°C
Capacity (2-side labeling):	Exceeds 5 pallets/min
Dimensions (WxDxH):	916 x 610 x 2047 mm

BROWSE ALL PRINT & APPLY APPLICATORS & PRINTERS